So far I have lights on this bluetooth board and have it hooked up to the FTDI board, trying to get it working. I got https://www.macupdate.com/app/mac/31352/coolterm and it's just a simple plug in USB cable and set settings.

I pulled the GPIO9 port to the ground port of the battery power to get it into command mode, which I then ran the following commands. D=display settings, SN=Set name, H=Help, R=reboot.

D
* Settings *
BTA=0006665206E1
BTName=RN52-06E1
Authen=1
COD=240704
DiscoveryMask=FF
ConnectionMask=FF
PinCod=1234
AudioRoute=00
ExtFeatures=04
SN,Rotary Gecko
AOK
D
* Settings *
BTA=0006665206E1
BTName=Rotary Gecko
Authen=1
COD=240704
DiscoveryMask=FF
ConnectionMask=FF
PinCod=1234
AudioRoute=00
ExtFeatures=04
H
* SET COMMANDS *
S-,<text>  - Serialized Name
S|,<hex8>  - Audio Route
S^,<dec>   - Auto Power Off timer
S%,<hex8>  - Extended features
SA,<dec>   - Authentication mode
SC,<hex24> - Class of Device
SD,<hex8>  - Discovery Mask
SF,1       - Factory Default
SK,<hex8>  - Connection Mask
SN,<text>  - Name
SP,<text>  - Pin Code

* ACTION COMMANDS *
@,<0,1>    - Disable,Enable Discovery
D          - Dump Configuration
K,<hex8>   - Disconnect
Q          - Connection Status
R,1        - Reboot
V          - Firmare Version

* AVRCP COMMANDS *
AV+        - Volume UP
AV-        - Volume Down
AT+        - Next Track
AT-        - Previous Track
AP         - Play/Pause

* CONNECTION COMMANDS *
A,<text>   - Initiate a voice call
B          - Reconnect to last device
C          - Accept incoming call
E          - Drop/Reject active or incoming call

* GPIO COMMANDS *
I@         - Show GPIO input/output mask
I@,<hex16>- Set GPIO input/output mask
I&         - Show GPIO input/output state
I&,<hex16> - Set GPIO output state
R,1
Reboot!
CMD